Home | Our Company | Our Services | Water Conditioning | Contact Us

The Well

This illustration is not intended to be an installation guide.
Check local codes for actual requirements and restrictions.

This information was provided courtesy of Campbell Manufacturing Inc.

1
Check Valve
Located at the top of the pump, it prevents backflow into the pump and hold the head of water in the system.
2
Brass Rope Adapter
Connects the Pitless Adapter and the Submersible Pump with Safety Rope.
3
IDEAL Clamps
All-stainless steel clamps for dependable connections between Pipe and Insert Fittings or Torque Arrestor.
4
Heat Shrink Splice Kit
For waterproof electric cable splices in submersible pump installations.
5
Torque Arrestor
Installed directly above Submersible Pump to protect pump and well components from starting torque damage.

6
Safety Rope
A safety line from the top of the well to the pump.
7
Cable Tie
Fastens Cable to Drop Pipe.
8
Cable Guard
Protects submersible cable wires from abrading against sides of well.   Two styles available: Self-clamping or Snap-in.
9
Pitless Adapter
provides a watertight, sanitary, removable connection between the pump and the house. Installed in the casing below the frost line to prevent freezing.
10
Brass Insert Fitting
Provides a connection between poly pipe and pipe thread of Pitless Adapter.

15
Drain Valve
For easy draining of the system.
20
SQUARE D Safety Switch
for electric control and distribution to the pump.
11
Watertight Well Cap
Inner gasket compresses to outside diameter of casing to provide a watertight seal. Top of cap removes easily to access well for service.
16
Brass Nipple
Male threads allow attachment of Pressure Switch to Tank Tee.
21
Motor Minder
Adjustable, solid state control that monitors system load conditions to protect pump motor from dry well, loss of flow, rapid cycling, slow recovery, air lock, and locked rotor problems.
12
Well Seal
Used in above-ground installations to provide a positive seal inside casing.
17
Relief Valve
Protects against pressure buildup. Should be used on any system where the pump could develop greater pressure than the maximum rating of the system.

22
Lightning Arrestor
Protects pump motor & controls from voltage surges caused by lightning, switching loads, and power line interference.
13
Check Valve
On pump installations, a Check Valve installed near the tank inlet holds water in the tank when the pump is idle.

18
Pressure Gauge
Measures water pressure in Pressure Tank.
23
Ball Valve
Acts as a shutoff valve on the supply line from the tank to the house.
14
Tank Tee
Connects water line from pump to pressure tank and service line from tank to house. Taps are provided to accept Pressure Switch, Pressure Gauge, Drain Valve, Relief Valve, Snifter Valve, etc.
19
Pressure Switch
Signals the pump to start when the water system drops to a preset low pressure, and to stop when the high pressure mark is reached.
24
Water Filter
A point-of-entry, whole-house filter that removes rust particles, sand, etc. from supply water.


This illustration is not intended to be an installation guide.
Check local codes for actual requirements and restrictions.

 

 

 

59 Highway 31 • PO Box 306 • Flemington • New Jersey • 08822 • (908) 782-2116 • info@stothoff.com

Home | Learn More | News | Forms | Contact Us